How to make a quick and easy graduation money holder
United States paper money, rolled up, fits diagonally in the box. If the height of your currency is larger than 2.75" (about 7cm) you will need a larger box.
You will need three pieces of card stock for the cap. Mine were 6.5" (about 15.4cm), 6" (about 16.7cm) and 3.5" (about 9 cm).
Make a box with a lid from the larger two pieces of card stock.
Written directions are all over the Internet, so I won't re-invent the wheel. Here are just a couple..and a video. I do like to dab a little glue under all the flaps on the inside of the box and lid to hold them in place.
Glue the smaller piece of card stock to the top of the box. Each corner of the box should point to the center of one side of the small piece of card stock.
Place a glue dot in the center top of the cap. Attach tassel.
Cut a circle of card stock large enough to cover glue dot and attach on top of tassel.
Cut a piece of lightweight paper slightly larger than your currency. Mine was 2.75" x 6.5". Print or write your sentiment on the paper. Roll up paper and currency together and tie with a small ribbon. If you have a tiny rubber band (I used one from tooth braces) you can use that--with or without a ribbon.
Extreme Cards and Papercrafting: pop up cards, movable cards, digital crafts and unusual papercrafts.